P 11/ 27
Wiring diagram
Fig. D-2A
RP2301FC with electric Brake, LED Job Light, Electronic Control
Wiring in Motor housing on Grip R side (Switch side)
When putting Lead wires for connecting to Terminal block, into this Lead wire holder, Controller’s thin Lead wire (purple) has to be put under the following Lead wires.
* Controller’s thick Lead wire (red)
* Thick Connecting lead wire (purple)
for connecting Switch to Terminal block
Lead Wire Holder
Terminal block
The extra portion of Controller’s thin Lead wires (black, red) to be connected to LED has to be put in this position.
Connector of Controller’s lead wires has to be connected to LED circuit that facies Lead wire (Red) to Red marking side.
And put the Lead wires into Lead wire holder.
Lead wire holder
Grip R
Switch lever
Connecting Lead Wires
(yellow, | orange purple) to |
be connected to Switch in | |
Grip R | Connector |
of Controller Red marking
Controller’s Lead wire (red)