Friedrich ZStar operation manual Before Installation, Begin Installation

Installation Instructions

A. BEFORE INSTALLATION

1.Insert the Guide Panels into the guides of the air conditioner. Fasten the Curtains to the unit with screws (TYPE A), as shown Fig. 6.

2.Cut the adhesive-backed seal strip (TYPE D) to the window width.

Remove the backing from the seal strip and attach the seal strip to the underside of the bottom window. (Fig. 7)

B. BEGIN INSTALLATION

1. LOCATING UNIT IN WINDOW

Open the window and mark center line on the center of the inner sill, as shown in Fig. 8.

TYPE A

Fig. 6

SEAL STRIP (TYPE D)

Fig. 7

TYPE A

ENGLISH

2.ATTACH L BRACKET

a.Install the L brackets behind the inner window sill, with short side of bracket as shown. Use the 2 screws (TYPE A) provided.

b.The bracket helps to hold unit securely in place. Be sure to place bracket edge flush against back of inner sill. See Fig. 9.

CAUTION

During the following step, hold unit firmly until window sash is lowered to top channel behind side panel frames. Personal injury or property damage may result if unit falls from window.

3.INSTALL THE AIR CONDITIONER IN THE WINDOW

a.Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L bracket. See Fig. 9.

IMPORTANT :

When the air conditioner drops into the L bracket, the air conditioner will be centered in window opening as shown in Fig. 10.

b. While steadying the air conditioner, carefully bring the window sash down behind the upper guide of the air conditioner, as shown in Fig. 11.

		CENTER LINE
INNER SILL
	ROOM SIDE
Fig. 8
	INNER SILL
OUTER SILL		TYPE A INSIDE
		CENTER LINE
		8"
		8"
	OUTSIDE
Fig. 9	L BRACKET

Fig. 10 CENTER LINE

WINDOW FRAME

UPPER GUIDE SEAL

ABOUT 1/4"

BOTTOM

GUIDE

Fig. 11

L BRACKET

9