Makita 3620A instruction manual Additional Safety Rules

Page 4

ADDITIONAL SAFETY RULES

1.Handle the bits very carefully.

2.Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately.

3.Avoid cutting nails. Inspect for and remove all nails from the workpiece be- fore operation.

4.Hold the tool firmly with both hands.

5.Keep hands away from rotating parts.

6.Make sure the bit is not contacting the workpiece before the switch is turned on.

7.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit.

8.Be careful of the bit rotating direction and the feed direction. (cf. P. 7)

9.Do not leave the tool running. Operate the tool only when hand-held.

IO.Always switch off and wait for the bit t o come t o a complete stop before removing the tool from workpiece.

11. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin.

12.Keep the bit retracted so as not t o protrude from the tool base except dur- ing actual operation.

SAVE THESE INSTRUCTIONS.

4

Image 4
Contents Router Safety Instructions Page Additional Safety Rules To remove the bit, follow the installation Page Page Page MA1NTENANCE Accessories Bits Hinge MortisingDovetail Round Nose Core BOX VEE GroovingPanel Pilot ~~~~~ Rounding Beading Cove Rabbeting ChamferingRoman Ogee Flute Flush Trimmer Combination FLUSH122 Bevel TrimmerL U T E Flush Replacementcutter Flute 22 Bevel Replacement CutterBall Bearing Pilot Router Hex Makita Limitedone Year Warranty