Makita 3620A instruction manual

Page 6

Next, lower the stopper pole until it makes contact with the adjusting hex bolt. Align the depth pointer with the "0" graduation.

Raise the stopper pole until the desired depth of cut is obtained. The depth of cut is indicated on the scale (1 mm or 1/16" per graduation) by the depth pointer. Then tighten the screw to secure the stopper pole.

Now, your predetermined depth of cut can be obtained by loosening the lock lever and then lowering the tool body until the stopper pole makes contact with the adjusting hex bolt.

CAUTION :

Since excessive cutting may cause overload of the motor' or difficulty in controlling the tool, the depth of cut should not be more than (5/8")a t a pass when cutting grooves with a (1/4") diameter bit.

[Note: When cutting grooves with an (3/4") diameter bit, the depth of cut should not be more than (1/4") a t a pass.] When you wish to cut grooves more than (5/8")deep with a (1/4") diameter bit or more than (1/4") deep with an (3/4") diameter bit, make several passes with progressively deeper bit settings.

Stopper block

The stopper block has three adjusting hex bolts which raise or lower 0.8 mm (about 1/32") per turn. You can easily obtain three different depths of cut using these adjusting hex bolts without readjusting the stopper pole.

Adjust the lowest hex bolt to obtain the deepest depth of cut, following the method of "Adjusting depth of cut". Adjust the two remaining hex bolts to obtain shallower depths of cut. The differences in height of these hex bolts are equal to the differences in depths of cut.

To adjust the hex bolts, first loosen the hex nuts on the hex bolts with the wrench and then turn the hex bolts. After obtaining the desired position, tighten the hex nuts while holding the hex bolts in the desired position.

The stopper block is also convenient for making three passes with progressively deeper bit settings when cutting deep grooves.

6

Image 6
Contents Router Safety Instructions Page Additional Safety Rules To remove the bit, follow the installation Page Page Page MA1NTENANCE Accessories Bits Hinge MortisingDovetail Round Nose Core BOX VEE GroovingPanel Pilot ~~~~~ Rounding Beading Cove Chamfering RabbetingRoman Ogee Flute Flush Trimmer Combination FLUSH122 Bevel TrimmerL U T E Flush Replacementcutter Flute 22 Bevel Replacement CutterBall Bearing Pilot Router Hex Makita Limitedone Year Warranty