001894 |
1 |
1. Switch trigger
Switch action
CAUTION:
•Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop.
| 001895 |
| 1 |
2 | 3 |
1.Reversing switch lever
2.Clockwise
3.Counterclockwise
Electric brake
This tool is equipped with an electric brake. If the tool consis- tently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center.
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation.
When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled.
CAUTION:
•Always check the direction of rotation before operation.
•Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
•When not operating the tool, always set the reversing switch lever to the neutral position.
|
|
|
|
|
| 001896 | Speed change | |
|
|
|
|
|
|
|
| To change the speed, first switch off the tool and then slide |
|
|
|
|
|
|
|
| the speed change lever to the “2” side for high speed or “1” |
|
|
|
|
|
|
|
| |
| 1 |
|
|
|
|
|
| side for low speed. Be sure that the speed change lever is |
|
|
|
|
|
|
| set to the correct position before operation. Use the right | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| speed for your job. |
|
|
|
|
|
|
|
| CAUTION: |
1. Speed change lever |
|
| ||||||
|
| • Always set the speed change lever fully to the correct | ||||||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| position. If you operate the tool with the speed change |
|
|
|
|
|
|
|
| lever positioned halfway between the “1” side and “2” |
10 |
|
|
|
|
|
| side, the tool may be damaged. | |