P 4/ 5
Repair
[2]DISASSEMBLY/ASSEMBLY FOR DC18WA U
[2]-1. Terminal unit and Charger case complete
DISASSEMBLING
Important: After disconnecting the charger from electric outlet, wait more than 5 minutes before repairing work. Replace Charger case complete as drawn in Figs. 5 and 6.
Fig. 5
1.Turn Charger upside down and remove four Tapping screws.
2.Turn Charger over again and open Charger case complete from rear side.
Charger case complete
Tapping
screws
Terminal unit
Indication of | *Open from | Charger case cover |
| ||
DC18WA U | this side |
|
Note: Terminal unit is fully integral with Charger case complete.
When it is necessary to replace Terminal unit, replacing
Charger case complete and Charging condition label is required.
Fig. 6
3. Hold the connector on Charging circuit and pull up the connector.
Charging circuit | Connector |
ASSEMBLING
Assemble Charger case complete to Charger case cover by reversing the disassembly procedure.
Be sure to push Power supply cord firmly between the ribs and the wall of Charger case cover as drawn in Fig. 7.
Fig. 7
Power supply cord |