P 3/ 5
Repair
[1]DISASSEMBLING / ASSEMBLING
[1]-2. Terminal cover
DISASSEMBLING
Remove 3x10 Tapping screw from the reverse side of the removed Charger case complete, then separate
a couple of Compression spring 4 from Terminal cover. Note: These compression springs are different from
Compression spring 4 behind Terminal unit.
Fig. 3
Charger case | 3x10 Tapping |
| screw |
Terminal cover | Compression |
spring 4 (2 pcs.) |
ASSEMBLING
Refer to Fig. 4.
Fig. 4
| Compression spring 4 | |
Retaining portion | Boss of Terminal cover | |
Retaining portion of | ||
Terminal | ||
Charger case to | ||
cover | ||
receive Compression | ||
| ||
Boss | spring 4 |
1.While compressing a couple of Compression spring 4 toward the retaining portions of Terminal cover, insert the boss of Terminal cover into the elliptic hole of Charger case.
2.Push the compression springs using Slotted screwdriver and fit them to the retaining portions of Charger case and Terminal cover.
Elliptical hole
Retaining portion of
| Compression | Retaining portion of Terminal cover |
| spring 4 | |
| to receive Compression spring 4 | |
Terminal |
| |
|
| |
cover |
|
|
Charger case to receive Compression spring 4
3.Drive 3x10 Tapping screw to the boss of Terminal cover. (Fig. 3) Note: The fastening torque has to be 0.5N.m. (5kgf.cm)