Craftsman 911 041 manual Charging a HOT Battery Pack, Charger can Also be Used for Products

CHARGING A HOT BATTERY PACK

When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Sears Repair Center for checking or replacing.

NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to "Charging

a Cool Battery Pack" for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Sears Repair Center for electrical check.

USE 11041 BATTERY CHARGER ONLY WITH

BATTERY PACKS LISTED BELOW.

TYPE 1 BATTERY PACK MODEL NUMBERS

(require1 hourto charge)

1310715,1322521,1322522,1323408,1323409,1323501,

1323502,1323505,1323506,1323513,1323514,1323516, 1323517, 1323903, 1323905, 1325101, 130235029,

130238003, 130238005, 130251008, 130279001,

130279002, 130279003, 130279004, 130279005, 130287001

CHARGER CAN ALSO BE USED FOR PRODUCTS

WiTH THE FOLLOWING iTEM NUMBERS

10153, 11044, 11045, 11068, 11375, 11403, 11426, 11427, 11428, 11430, 11442, 11448, 11453, 11462, 11485, 11512, 11516, 11538, 11539, 11540, 11541,11542, 11543, 11544, 11545, 11546, 11574, 11575