Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before use of this product.
Battery Pack (Item 68860, sold separately)
Red
LED Green
LED
Charge
Base
Battery Pack Set Up
Note: Battery Pack sold separately (Item 68860).
1.Allow the battery pack to cool completely before charging
2.Inspect the battery pack before charging; do not charge a cracked or leaking battery pack.
General Operating Instructions
1.Plug the Charger into a grounded, 120 V~, 60 Hz outlet. Do not use an extension cord.
Note: The Green LED will light to show the power is connected and remain lit throughout the charging process while the cord is connected.
Charging Area Set Up
1.Use on dry, flat, fireproof surface only. The Charger gets hot during use. The Charger’s heat can build up to unsafe levels and create a
fire hazard if it does not receive adequate ventilation, due to an electrical fault, or if it is used in a hot environment. Do not place the Charger on a flammable surface.
2.Do not obstruct any vents on the Charger.
3.Especially avoid placing the Charger on carpets and rugs; they are
not only flammable, but they also obstruct vents under the Charger.
4.Place the Charger on a stable, solid, nonflammable surface (such as a stable metal workbench or concrete floor) at least 1 foot away from all flammable objects, such as drapes or walls.
5.Charging room temperature: 50° - 104° F
6.Keep a fire extinguisher and a smoke detector in the charging area.
2.Slide the Battery Pack into the Charger until the button on the Battery Pack clicks into place. The Red LED will flash to show the Battery is charging.
Note: If the Battery does not fit properly, disconnect it and confirm that the Battery Pack is the correct model for this Charger as shown on the Specification chart. Do not charge any other Battery Pack or any Battery Pack that does not securely fit the Charger.
3.Frequently monitor the Charger and battery pack while connected.
4.For a fully discharged battery or a new battery, allow the Battery Pack to Charge for 1 hour. The Red LED will stay on when the
battery is finished charging.
5.Unplug the Charger and disconnect it from the Battery Pack when finished.
6.Allow the Battery Pack to cool completely before using it.
7.Store the Charger and Battery Pack indoors, out of reach of children.
Item 68859 | For technical questions, please call | Page 5 |