5.The battery is charged when the GREEN light is blinking. If a 100 % state of charge is not needed the battery can be used when the meter indicates low charging current.
NOTES:
a.If the charger is connected to a battery which will not accept a charge, the charging cycle will end and the GREEN light will blink.
b.If the charger is connected to a fully charged battery the charger will shut off and the GREEN light will blink.
c.If the clamps are removed during the battery test sequence the charger will shut off and the GREEN light will blink.
d.It is best to reset the charger control before beginning to charge another battery. This can be accomplished by pulling the AC Power Switch OFF « F » then ON « I » again.
e.Any time a malfunction is suspected reset the control by turning the AC Power Switch OFF « F ».
VEHICLE STARTING:
1.Charge the battery for a minimum of 10 minutes using the procedure above.
2.Put the selector switch in the ENGINE START position.
3.Attempt to start the vehicle. If the engine does not start, put the selector switch back to the CHARGE position for another 10 minutes before trying again.
NOTE: The output circuit breaker may open during the engine start. It will reset in a few seconds and battery charging will continue.
WIRING DIAGRAM
15