Associated Equipment 9305 important safety instructions Battery Charger, Operators Manual

Page 1

 

 

 

BATTERY CHARGER

 

 

 

 

 

 

OPERATOR'S MANUAL

 

 

 

IMPORTANT SAFETY INSTRUCTIONS

ASSOCIATED

1.SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for Model 6018. You may need to refer to these instructions at a later date.

2.CAUTION. To reduce risk of injury, charge only wet cell, lead-acid, automotive type rechargeable batteries. Other types of batteries may burst causing personal injury and property damage.

3.Do not expose charger to rain or snow.

4.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons.

5.To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.

6.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

7.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If an extension cord must be used, make sure:

a.That pins on plug of extension cord are the same number, size, and shape as those of plug on charger;

b.That extension cord is properly wired and in good electrical condition; and

c.If the length of the extension cord is less than 25 feet, use a 16AWG cord, If 50 feet- 12AWG, 100 feet-10AWG, 150 feet-8AWG.

8.Do not operate charger with damaged cord or plug, replace the cord or plug immediately.

9.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

10.Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

11.To reduce risk of electric shock, unplug charger form outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.

12.WARNING - RISK OF EXPLOSIVE GASES

a.WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.

b.To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer of any equipment you intend to use in vicinity of battery. Review cautionary marking on these products and on engine.

13.PERSONAL PRECAUTIONS

a.Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery.

b.Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.

c.Wear complete eye protection, and clothing protection. Avoid touching eyes while working near battery.

d.If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enter eye, immediately flood eye with running cold water for at least 10 minutes and get medical attention immediately.

e.NEVER smoke or allow a spark or flame in vicinity of battery or engine.

f.Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short circuit battery or other electrical part that may cause explosion.

g.Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead-acid battery. A lead-acid battery can produce a short circuit current high enough to weld a ring or the like to metal, causing a severe burn.

h.Use charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low-voltage electrical system other than in a starter motor application. Do not use battery charger for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage to property.

i.NEVER charge a frozen battery.

14.PREPARING TO CHARGE

a.If necessary to remove battery from vehicle to charge, always remove the grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc.

b.Be sure area around battery is well ventilated while battery is being charged. Gas can be forcefully blown away by using a piece of cardboard or other non-metallic material as a fan.

c.Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.

d.Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. This helps purge excessive gas from cells. Do not overfill. For a battery without cell caps, carefully follow manufacturer's recharging instructions.

e.Study all battery manufacturer's specific precautions such as removing or not removing cell caps while charging and recommended rates of charge.

f.Determine voltage of battery by referring to car owner's manual and make sure that output voltage selector switch is set at correct voltage. If charger has adjustable charge rate, charge battery initially at lowest rate.

15.CHARGER LOCATION

a.Locate charger as far away from battery as dc cables permit.

b.Never place charger directly above battery being charged; gases from battery will corrode and damage charger.

c.Never allow battery acid to drip on charger when reading gravity or filling battery,

d.Do not operate charger in a closed-in area, or restrict ventilation in any way.

e.Do not set a battery on top of charger.

16.DC CONNECTION PRECAUTIONS

a.Connect and disconnect dc output clips only after setting any charger switches to off position and removing ac cord from electric outlet. Never allow clips to touch each other.

b.Attach clips to battery posts and twist or rock back and forth serval times to make a good connection. This tends to keep the clips from slipping off terminals and helps to reduce risk of sparking.

17.FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE. A SPARK NEAR BATTERY MAY CAUSE BATTERY

1

Image 1
Contents Operators Manual Battery ChargerGrounding and AC Power Cord Connection Instructions EXPLOSION. to Reduce Risk of a Spark Near BatteryLength of Charge Operating Instructions Assembly InstructionsMaintanence Instructions To Obtain Services Under this Warranty Limited WarrantyAssociated Equipment Corporation 5004 Brown Avenue 13. Précautions Personnelles Charger DE Batterie Manuel Dutilisation14. Préparation DE LA Charge Periode DE Charge Emplacement DU ChargeurInstructions D’UTILISATION Instructions DassemblagePour Charger LA Batterie Demmarrage PAR SuralimentationLA Guarantie Instructions Pour LentretienPrecauciones Personales Cargador DE Baterias Manual DEL OperadorPreparando Para Cargar Colocación DEL CargadorInstrucciones DE Conexión DEL Cable AC a Tierra Precuaciones DE LA Conexión DCDuración DE LA Carga Instrucciones DE Funcionamiento Instrucciones DE EnsamblajeInstrucciones DE Mantenimiento USO DEL Interruptor DE Estado DE CargaPara Obtener Servicio CON Esta Garantia Garantia LimitadaW2224