APC BR1000G Function Button Quick-Reference, Function Button Timing, Description, Seconds, Status

Function Button Quick-Reference

Function	Button	Timing	UPS	Description
		(seconds)	Status
Power

Power On

Power Off

0.2Off

2 On

Press POWER to start receiving input utility power. If A/C input power is not available, the Back-UPS will run on battery power.

The Back-UPS is not receiving input utility power, but is providing surge protection.

Display

Status Inquiry

Full-Time/Power- Saving mode

Mute

0.2On

2 On

Verify the status or condition of the Back-UPS. The LCD will illuminate for 60 seconds.

The LCD will illuminate and the Back-UPS will beep to confirm the Full-Time mode. The LCD will darken and the Back-UPS will beep to confirm the Power-Saving mode. While in Power-Saving Mode, the LCD will illuminate if a button is pressed, then darkens after 60 seconds of no activity.

Event Specific	0.2	On
General Status Enable/	2	On
Disable

Disable any audible alarms caused by an event.

Enable or disable the audible alarms. The Mute icon will illuminate and the Back-UPS will beep one time. The Mute function will not activate unless the Back-UPS is operating on battery power.

Sensitivity	6	Off	The Load Capacity icon will blink, indicating that the Back-UPS is
			in programming mode. Use the POWER button to scroll through
			Low, Medium, and High, stop at selected sensitivity. The Back-
			UPS will beep to confirm selection. See Configuration for details.
Master/Controlled	2	On	The leaf icon will darken indicating that the Master Outlet feature is
outlet Enable/Disable			disabled or illuminate to indicate the Master Outlet feature is
			enabled. The Back-UPS will beep once.
Master/Enable	6	On	While calibrating the threshold setting, the device connected to the
Threshold Calibration			Master Outlet should be turned off or placed in Standby or Sleep
			mode. Upon completion, Power-Saving icon will flash 3 and beep
			3 times.
Self-Test (manual)	6	On	The Back-UPS will perform a test of the internal battery. Note: This
			will happen automatically when the Back-UPS is turned ON.

Event Reset

Fault Reset

0.2	On	When the Event screen is visible, press and hold DISPLAY, then
		press POWER, to clear the utility failure event counter.
2	Fault	After a fault has been identified, press POWER to remove the
		visual indication and return to standby status.

6 Back-UPS Pro 1000 Installation and Operation