Kawasaki 840563 Maintenance and Cleaning, Accessories, Tool Current Rating, Specifications

•Mark out the line to be cut so it is easily visible.

• Start inside the area to be cut out.

• Set the shoe against the work piece at an angle.

• Lift the blade guard.

• Pull the trigger to start the saw.

•When the blade reaches full

speed, slowly feed the blade into the work piece. When the blade starts cutting, release the blade guard.

MAINTENANCE AND CLEANING

This Circular Saw is lubricated before it leaves the factory. This lubrication should last for the life of the tool. No further lubrication is required.

Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the casing. Never immerse any part of the tool in a liquid. Always keep the ventilation openings clear.

Regularly clean the ventilation slots in your tool and charger using only a soft brush or dry cloth.

Inspect all mounting screws regularly. Tighten any loose screws. Failure to keep the mounting screws tight could result in serious injuries.

Never open the Circular Saw case. Do not attempt to repair the Circular Saw your- self. Opening the tool will void your warranty.

LASER MAINTENANCE

For best performance, perform the following maintenance regularly:

Disconnect machine from power source. Carefully clean sawdust from laser lens with a cotton swab. Do not use solvents of any kind since they may damage the lens.

ACCESSORIES

Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.

Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.

If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current necessary for your power tool. If not, your tool may experi- ence a loss of power, excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord (see table on below).

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS

TOOL CURRENT RATING		CONDUCTOR SIZE IN A.W.G
AMPERE	10FT.	25FT.	50FT.	100FT.
3-6	18	18	18	18
6-8	18	18	18	16
8-10	18	18	18	14
10-12	16	16	14	14
12-16	14	12	12	-
16-20	12	12	12	-

	SPECIFICATIONS
SPECIFICATIONS
Input	120V	60Hz 10 Amp
No-Load Speed	4500 RPM
Blade Diameter	7-1/4"
Max. Depth of Cut	2-1/8" (55MM) @ 90°
	1-1/2" (38MM) @ 45°

OTHER CONSUMER DO-IT-YOURSELF (DIY) TOOLS

Alltrade offers a full range of Kawasaki™ tools that make DIY jobs easy. If you would like further information on the following products, please contact Alltrade Customer Service Department at 1-800-590-3723.

17 18