Kawasaki 840271 Drill BIT Insertion / Removal, Operating the Drill, Operating the on / OFF Switch

Page 6

DRILL BIT INSERTION / REMOVAL

• Unplug the drill. Never change bits on a live drill.

• Make sure the bit is undamaged, sharp and

free from wood or metal shavings. Foreign

material on the bit may keep the chuck from tightening fully. A loose bit may cause injury.

• Push the bit into the chuck as far as it will go.

• Make sure the bit is in the center of the chuck. If the bit is off-center, it will not be held securely and may fly loose during use causing serious injury.

• Insert the chuck key into one of the three chuck holes. Rotate the chuck key clockwise to lock the bit in place.

Remove the chuck key.

Store the Chuck Key after each use in its holder located at the power cord stem.

Always run the drill for one minute before drilling to make sure the bit is properly seated. If the bit needs to be adjusted, unplug the drill before touching the bit.

OPERATING THE DRILL

In certain situations, the bit may bind and the drill will kick- back in the opposite direction. This sudden reaction could lead to loss of con- trol and possible serious injury. Always be prepared for the possibility of kick- back, especially when breaking through material to complete a hole.

OPERATING THE ON / OFF SWITCH

Squeeze the trigger switch to turn the tool “ON”. Release the trigger switch to turn the tool “OFF”.

When drilling for extended periods, the “Lock-On” switch may be used, but do not use this switch in situations where the drill is likely to bind or kickback. If kickback does occur, the sudden motion of the tool may make it difficult to release the “Lock-On” switch and turn the drill off.

SPEED CONTROL ADJUSTING SWITCH

To increase the operating speed of the drill, turn the variable speed control clockwise. To decrease the speed, turn the variable speed control counterclockwise.

9

10

Image 6
Contents Variable Speed Electric Hammer Drill Recognize Safety SYMBOLS, Words and Labels Table of ContentsGeneral Safety Rules for ALL Electric Power Tools CongratulationsPersonal Safety Important SafeguardsElectrical Safety Save These Instructions for Future ReferenceImportant Safety Rules for Hammer Drills ServiceSpecific Safety Rules AND/OR Symbols Tool USE and CareAssembly SymbolsSymbol Name Explanation Functional DescriptionDrill BIT Insertion / Removal Operating the on / OFF SwitchSpeed Control Adjusting Switch Operating the DrillHammer / Drill Selector Reversing Switch LeverUsing the Depth Gauge Drilling WoodSpecifications Maintenance and CleaningAccessories Drilling MetalYear Limited Warranty Warranty PerformanceCommercial or Rental Purpose Warranty Disclaimers Limitation Of Liability