For your convenience, a spare light bulb is included inside the unit. Unscrew the rim and carefully remove it from the light assembly.
Equipment service must be performed only by qualified repair personnel using authorized replacement parts. Service or maintenance by unqualified personnel could result in considerable risk of personal injury. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
1.Remove the battery pack from the Worklight.
2.Hold the top of the Worklight with one hand while twisting the rim in a
3.Remove the bulb by turning it slightly and pulling it out of the bulb fitting. Be careful not to damage the delicate parts inside the case.
4.Insert the new bulb, then carefully put the rim back in place and turn it clockwise to tighten it.
REPLACEMENT BULB
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.
Always attach grounded
If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current necessary for your power tool. If not, your tool may experience a loss of power, excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord (see table below).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING |
| CONDUCTOR SIZE IN A.W.G |
| |
AMPERE | 10FT. | 25FT. | 50FT. | 100FT. |
18 | 18 | 18 | 18 | |
MAINTENANCE AND CLEANING
Always remove the battery pack before attempting cleaning or maintenance.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the casing. Never immerse any part of the tool in a liquid. Always keep the ventilation openings clear.
Always clean the battery pack using only a dry cloth. Do not use liquids. Always unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool and charger using only a soft brush or dry cloth.
Never open the Worklight case, battery pack or charger. Do not attempt to repair the Worklight, battery pack or charger yourself. Opening any of these parts will void your warranty.
Use only authorized replacement parts for your tool.
18 | 18 | 18 | 16 | |
18 | 18 | 18 | 14 | |
16 | 16 | 14 | 14 | |
14 | 12 | 12 | - | |
12 | 12 | 12 | - |
SPECIFICATIONS
SPECIFICATIONS |
|
|
|
Voltage | 19.2V |
|
|
|
| ||
Light Bulb Type | Krypton 18V 0.3A | ||
Charger Input | 120V |
| 60Hz |
Charging Time | Approx. 1 Hour | ||
Battery Type |
|
| |
11 | 12 |