Output | Tyco 92136-0920 instruction

CAUTION-ELECTRIC TOY:

NOT RECOMMENDED FOR CHILDREN UNDER 8 YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK. INPUT:

OUTPUT:

™

92136-0920TMH™ Flex Pak™ Battery Pack & Charger

The WAIT is OVER. The FLASH CHARGE ™ power system charges

8 TIMES FASTER! Conventional chargers take 4 HOURS to charge your R/C battery. The FLASH CHARGE ™ system charges in about 30 MINUTES! It’s BREAKTHROUGH TECHNOLOGY that works with ALL TMH ™ powered R/C vehicles.*

* Please see FLASH CHARGE COMPATIBILITY on page 2.

•Your vehicle’s running time will vary depending on its power consumption (and your driving style). A high-performance vehicle driven at full speed, with fre- quent turns and stunts, will give the shortest running time between charges. For maximum performance, please read all instructions before operating.

•Pick up extra batteries for non-stop action! With one in your car and one in the charger, it’s practically “perpetual motion!”

TO CHARGE THE BATTERY PACK, PLEASE FOLLOW THESE INSTRUCTIONS:

1.Plug the charger into standard wall outlet.

2.Raise the charger door as shown.

3.Hold the battery pack fully open, with the metal contacts at the top, as shown. The labels marked 1 and 2 in the upper left-hand corner should be facing you. Now slide the battery pack securely into the charger, make sure the battery pack is fully inserted into charger.

4.Close the charger door. Clicking the charger door shut begins the charging process; the battery pack cannot be charged with the charger door open. The red LED will light to show that charging is in progress.

5.The charging process will take approximately 30 minutes. Charging is complete when the green charger LED lights.

6.After charging, remove the battery pack as follows. Raise the charger door. Press the two release buttons at the same time and slide the battery pack out of the charger.

7.After charging, the battery may feel warm. This is normal for fully charged batteries.

8.Never attempt to recharge a hot battery. Allow a hot battery to cool down before recharging.

9.Unplug charger when not in use.

Your Flash Charge charger features an exclusive dual-LED status monitor. Whenever the charger is plugged in and a battery pack is inserted, the LEDs will indicate battery charging status.

Solid red LED: charging in progress.

Solid green LED: charging complete.

Blinking LEDs may indicate a problem with the charger or the battery pack.

Keep these instructions for future reference: they contain important information.

LED

Status Monitor

Charger Door

Release Button (one each side)

Blinking red charger LED: the battery pack can’t be charged right now (too hot, too cold or overly “run down” between charges). Leave the battery pack in the charger and the charger plugged in. Within 30 minutes the LED should change to solid red, and normal charging should begin. If not, please call the TYCO® R/C Consumer Affairs toll-free number for assistance.

Blinking green charger LED: the battery pack did not accept a “full” charge (too cold, too old or already charged). The battery pack may be used. Follow normal charging procedure after use.

Slowly blinking red and green charger LEDs: possible charger problem (too hot, too cold, moisture in charger, etc.). Unplug the charger and remove the battery pack. Leave the charger inside at room tempera- ture for 30 minutes. Try charging again. If the problem persists, please call the TYCO® R/C Consumer Affairs toll-free number for assistance.

Quickly blinking red and green charger LEDs: battery pack contacts may be dirty. Remove the battery pack and clean the metal contacts with a clean dry cloth. Try charging again. If the problem persists, please call the TYCO® R/C Consumer Affairs toll-free number for assistance.