Specifications
| MODEL NUMBER: | APSINT612 |
| AC Input Connection: | Detachable Input Cord |
|
|
|
| INVERTER |
|
| Output Volts (Nominal): | 230 VAC, ± 5% |
| Output Frequency (Nominal): | 50 Hz, ± 0.5% |
| Efficiency: | 88% to 94%, depending on load and temperature |
| Continuous Power (@ 20 C): | 600 |
| OverPower™ Peak Surge Power:* | 900 |
| Double Boost™ Peak Surge Power:* | 1200 |
| DC Input Volts (Nominal): | 12 VDC |
| DC Input Voltage Range: | |
| Minimum DC Fuse Rating: | 100 A |
| DC Input Current @ Nominal V DC Full Load: | 56 A |
|
|
|
| BATTERY CHARGER |
|
| Input Volts (Nominal): | 230 VAC |
| Charging Capacity DC: | 20 A |
| Acceptance Volts VDC Selectable (Wet**/Gel): | 14.4 V (14.2 V) |
| Float Volts VDC (w/gel): | 13.3 V (13.6 V) |
| Input Current AC (Maximum): | 2.2 A |
|
|
|
| LINE VAC OPERATION |
|
| Minimum Input Volts (Transfer to Battery): | Selectable 144,** 163, 182 or 201 VAC |
| Maximum Input Volts (Transfer to Battery): | Selectable 259** or 278 VAC |
| Input Frequency (Nominal): | 50 Hz, ±10% |
| Total Input AC Current (Continuous, Charger at Maximum): | 4.8 A |
| Maximum Output Current (Continuous): | 2.6 A |
*OverPower duration (up to 1 hour). DoubleBoost duration (up to 10 seconds). Actual duration depends on battery age, battery charge level and ambient temperature. ** Factory setting. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
Minimum Recommended Cable Sizing Charts†
Use in conjunction with DC wiring connection instructions in the Battery Connection section.
|
|
| Inverter/Charger DC Volt: 12 |
| ||
|
|
|
|
|
|
|
|
|
|
| Wire Gauge |
|
|
|
|
|
|
|
|
|
| Watts | 6 | 4 | 2 | 0 | 00 (2/0) |
| 500 | 4.8 m (15 ft) | 7.6 m (25 ft) | 11.9 m (39 ft) | 18.9 m (62 ft) | 24.1 m (79 ft) |
| 700 | 3.4 m (11 ft) | 5.5 m (18 ft) | 8.5 m (28 ft) | 13.4 m (44 ft) | 17.1 m (56 ft) |
† NOTE: Acceptable power is directly related to cable length (i.e. - the shorter the cable, the better the performance)
Note on Labeling
Two symbols are used on the APS labels.
V~: AC Voltage |
| : DC Voltage |
|
Limited Warranty
Tripp Lite warrants its Inverter/Chargers to be free from defects in materials and workmanship for a period of one year (except for outside of U.S.A., Canada and
Tripp Lite’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products. To obtain service under this warranty you must obtain a Returned Material Authorization (RMA) number from Tripp Lite or an authorized Tripp Lite service center. Products must be returned to Tripp Lite or an authorized Tripp Lite service center with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of pur- chase. This warranty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been altered or modified in any way, including opening of the unit’s casing for any reason. This warranty applies only to the orig- inal purchaser who must have properly registered the product within 10 days of retail purchase.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclu- sion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POS- SIBILITY OF SUCH DAMAGE. Specifically, Tripp Lite is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
2A