7.When the battery is fully charged, the Battery charger will automatically shut off. Note:When set in 6 volt mode, the Battery Charger will not automatically shut off; it must be manually turned off.
8.Remove the negative (black) Cable Clamp from the battery.
9.Remove the positive (red) Cable Clamp from the battery.
Maintenance
1.Using a clean cloth, wipe the Cable Clamps and charger of all grease and dirt.
2.Coil all cables.
3.Store the Battery Charger in a clean and dry location.
4.If any cable insulation becomes cracked and exposes copper wire, have it repaired or replaced by a qualified technician.
Troubleshooting
Symptom | Probable Causes | Remedy | |
|
|
| |
Maximum | Defective battery | Check and/or replace battery | |
ammeter reading | |||
|
| ||
| No power to charger | Check power cable and outlet | |
| connections | ||
|
| ||
No ammeter | Battery cable clamps not | Clean battery terminals and reset | |
reading | connected to battery properly | ||
cable clamps | |||
|
| ||
| Defective battery | Check and/or replace battery | |
|
| ||
|
|
| |
| Battery is partially charged | Continue charging | |
Charging current |
|
| |
not to full output | Defective battery, will not hold | Check and/or replace battery | |
| full charge |
| |
| Battery is completely dead | Continue charging battery. Charger | |
Ammeter needle |
| will continue to reset itself until the | |
| battery charge reaches a chargable | ||
moves up to full |
| ||
| level. | ||
charge, then |
| ||
|
| ||
drops to zero. | Defective battery | Check and/or replace battery | |
Makes clicking | |||
|
| ||
noise. | Charger is resetting itself | Wait until charger automatically | |
| |||
| after circuit breaker overload | resets itself. |
Note: No replacement parts are available for the Battery Charger.
SKU 45005 For technical questions, please call | Page 10 |