Specifications
Charge Time | ||
|
| |
Power Source | (5), 1.2V, 600 mAh/6V, | |
rechargeable battery pack | ||
Range | Detects motion over a range of | |
120° at 16 feet. | ||
| ||
Delay | ||
|
| |
Working | 14° - 131° F | |
Conditions | <80% RH |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Assembly
Read the entire Important Safeguards section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Note: For additional information regarding the parts listed in the fol- lowing pages, refer to the Assembly Diagram near the end of this manual.
2.The Security Light should be set up at a location where you desire to have extra lighting to detect persons or objects moving at night or in the dark.
3.Decide where you want to place the Lamp (1) and Solar Panel (2). The Light is equipped with a connect- ing wire, so the Lamp (1) and Solar
Panel (2) can be installed only as far apart as the connecting wire allows.
4.Choose a location that receives full, direct sunlight a minimum of eight hours a day. The location should not be near nighttime light sources such as porch lights or streetlights as this will cause the Light to remain off.
5.During the day, the Solar Panel con- verts sunlight into electricity which recharges the batteries. The amount of light the Solar Panel receives depends on placement of the Light, geographic location and weather. If the weather is cloudy and the panel did not receive a full charge, the Light may not achieve full operating time.
6.Mount the Lamp (1) on a solid sur- face capable of supporting the Lamp
(1) and secure enough so that it will not move when exposed to vibration or wind.
Figure 1
rear- mounting holes
inside- mounting holes
7.To mount the Lamp (1), the Screws
(5) can be inserted into either the rear mounting holes or to the inside mounting holes as shown in Fig. 1. If using the inside mounting holes,
SKU 98085 | For technical questions, please call | Page 4 |