Graco 24D107 Return Tube Kit, Keep a and B compo- nents separate, Assemble return tube kit

Return Tube Kit

Return Tube Kit

The Return Tube Kit can be installed singly or as a pair. Two are included in the Circulation Kit, page 3.

1.Keep A and B compo- nents separate

CAUTION

To prevent cross-contamination of fluid, mark A com- ponent (ISO) connections with red tape. Mark B com- ponent (RES) connections with blue tape. Do not interchange or cross-connect A component and B component parts.

2.Assemble return tube kit

Remove dryer carriage (C). Using awl or similar tool, punch a few small holes in each end of car- riage. Reinstall carriage.

Remove large fitting included with dryer (10). It is not needed for this application.

Apply thread sealant (8) to threads. Assemble return tube kit as shown at right.

3.Install kit in drum

Open drum port. Lower kit into drum. Screw tee

(6) into drum port to secure. Use bushing (5) to adjust position of tube (4) in tank.

4.Install circulation kit, page 3

WARNING

To reduce the risk of serious injury including fluid injection, use high pressure return hoses rated to with- stand the maximum working pressure of the propor- tioner. See proportioner operation manual.

		Return Tube Kit
				Qty
Ref.		(CS)	(SST)
No.	Description	246477	24D106
1	ELBOW, 90°; 1/2 in. (13	117532	16C635	1
	mm) OD tube x 1/2 npt(m)
2	FERRULE, tube; sst	117453	117453	1
3	NUT, tube, flareless	117454	16C636	1
4	TUBE; sst; 1/2 in. (13 mm)	15C514	15C514	1
	OD; 4 ft (1.2 m)
5	BUSHING, strain relief; 3/4	117811	117811	1
	npt(m)
6	TEE, street; 3/4 npt (mxf)	111337	16C637	1
	run; 3/4 npt(f) branch
8	SEALANT, pipe; 6 ml	110110	110110	1
10	KIT, accessory, desiccant	247616	247616	1
	dryer

1Apply thread sealant (8) to threads.

2Punch holes in ends of carriage (C).

1

2 C	2
	3
	4
10
	5
	6	1

TI3446a

1

2 309852E