16 | Installation (for qualified installers only) |
Steps for Installing the Battery Box and Learn Switch
1.Remove the control cover and attach the 12’ long battery box wire to the quick connects on the receiver module (see Figure 9 below). Route the battery box wire through the opening below the cover. At this time make sure the continuous pilot switch is set to “OFF” and the remote switch is set to “REMOTE” on the receiver module – item “a”). You may also wish to verify all the wire leads are fully attached.
Pilot Assembly
Battery Box
(external junction box)
|
| Igniter ("I") Wire |
|
| (Orange - with |
| Receiver | fiberglass |
| insulation) | |
Learn Wires | Module |
|
Two White Wires |
|
|
|
| Sensor ("S") |
Motor Wires (for flame height adjustment) |
| Wire (White) |
Red, Yellow, White, and Blue wires |
|
|
Battery Wires
Red and White Wires
Gas Control Valve
| Learn |
|
MOTOR |
| I |
COMM |
|
|
. |
| S |
POWER |
| ADJ |
AC Adapter | Continuous | Remote/Off |
| ||
Pilot |
| |
Off/On |
| |
(wire orientation does not matter) |
|
|
| a | Make sure continuous pilot | |
|
| is set to "OFF" and remote | ||
|
| Black | is set to "REMOTE". | |
| Brown Switch |
| ||
|
|
| ||
| Wires (not |
|
| |
| used) | Ground |
| |
Main Burner | Control Wires | Accent Light Wires | ||
Orange and White Wires | ||||
|
| |||
White
Green
Orange
White
Pilot Flame Control Wires
Power Input
Auxiliary Power
(Not Used)
Make sure continuous pilot is set to "OFF" and remote is set to "REMOTE".
120V Extension Module
Figure 9
2.Determine a location for the
3.Insert the battery box wires through the junction box, leaving approximately 8” of slack so the battery pack may be removed and the batteries replaced. Use a staple or other means to secure the wiring to the framing – this prevents the wires from slipping out of the junction box in the event the wires become disconnected from the battery pack (see Figure 8). NOTE: The wiring is
4.Place batteries inside the battery pack and place it inside the junction box. Attach the remote holder to the junction box with the included screws.
INSTALLATION WARNING – Remote Synchronization
At this time we highly recommend you verify the remote and fireplace are synchronized. This process requires access to the learn switch. See the instructions on page 17 for details.
Battery Installation
This fireplace uses four AA batteries for operation during power outages. Place the batteries into the battery box. In addition, two AAA batteries are required for the transmitter.
© Travis Industries | 4090102 |
