36 Finalizing the Installation (for qualified installers only)
Steps for Finalizing the Installation
WARNING: Prior to removing the glass, shut off gas to the appliance (or remove the batteries from the battery box and shut off electricity to the fireplace). This prevents any chance of accidental burner ignition when accessing the firebox.
1.Remove the glass (see page 38).
NOTE: If using propane (LP) convert the appliance prior to installing the logs (see page 43 for details)..
2.We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected once it enters the firebox, ensuring gas does not build up.
3.Install the firebacks (see instructions included with firebacks) and logs (see page 39).
4.Turn on the gas to the fireplace. Turn on gas to the heater. Leak test all gas joints.
5.Replace the glass. Start the pilot.
6.Start the main burner. Leak test all gas joints again (the gas control valve and connections are located on the exterior of the fireplace on the left side.
© Travis Industries | 4090102 |
