ELECTRICAL SAFETY
4.Grounded lights must be plugged into an outlet properly installed and grounded in ac- cordance with all codes and ordinances. Never remove the grounding prong or mod- ify the plug in any way. Do not use any adapter plugs. Check with a qualified elec- trician if you are in doubt as to whether the outlet is properly grounded. If the tools should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user.
5.Double insulated lights are equipped with a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electri- cian to install a polarized outlet. Do not change the plug in any way. Double insulation eliminates the need for the three wire grounded power cord and grounded power supply system.
6.Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerators. There is an increased risk of electric shock if your body is grounded.
7.Do not expose the Clamp Light to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
8.Do not abuse the Power Cord. Never use the Power Cord to carry the light or pull the Plug from an outlet. Keep the Power Cord away from heat, oil, sharp edges, or moving parts. Replace damaged Power Cords immediately. Damaged Power Cords increase the risk of electric shock.
9.When operating a light outside, use an outdoor extension cord marked
PERSONAL SAFETY
10.Stay alert. Watch what you are doing, and use common sense when operating the Clamp Light. Do not use the Clamp Light while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating the light may result in serious personal injury.
11.Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts.
12.Avoid accidental starting. Be sure the Power Switch is off before plugging in. Carrying the Clamp Light with your finger on the Power Switch, or plugging in the light with the Power Switch on, invites accidents.
13.Remove adjusting keys or wrenches before turning the Clamp Light on. A wrench or a key that is left attached to a rotating part of the light may result in personal injury.
14.Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the Clamp Light in unexpected situations.
SKU 35149 | For technical questions please call | Page |