Dometic 7020 dimensions Carry-On 7000 Portable Air Conditioners Introduction

Carry-On 7000 Portable Air Conditioners • Introduction

You have purchased a marine air conditioner that will add to your boating enjoyment. Please read the accompanying instructions to insure proper installation, operation and care.

Warnings

The use of the Carry-On™ is not recommended while the boat is under way because of the potential for damage to the Carry-On or the boat or the potential for personal injury.

The National Electrical Code recommends the use of a cord labeled with LCDI or AFCI when connecting a room air conditioner to power. LCDI stands for Leakage Current Detection and Interruption; AFCI stands for Arc Fault Circuit Interruption. Both help prevent fires and electrical shock. Dometic recommends that you contact your dealer and request part LCDI25 (25' cord) or purchase a similar cord from another supplier.

The Carry-On unit weighs 77 lbs (34.9 kg). Please get assis- tance when moving or lifting the Carry-On to prevent injury.

Dimensions & Hatch Size

The Carry-On is 19" (483mm) High, but only 14 5/8" (371mm) above deck when installed. The unit is 33"

(838mm) Long and 16" (406mm) Wide. For proper installa- tion, the minimum hatch size is 12" (305mm) square, and the maximum hatch size is 24" (610mm) square. The minimum round hatch diameter is 15 1/2" (394mm).

Important Information

Please make sure you have the following items. If you are missing any of these items please contact your dealer.

(1)CO-7000 Carry-On Portable Air Conditioning Unit

(1)Hatch Bag

(1)Air Deflector

(2)23" Batten Rods

(2) 25-1/2" Batten Rods

Before installing the unit you will need:

A power extension cord rated at 15 amps for 115V unit or 10 amps for a 220V unit. (See section, “Safe Operation of Carry-On”)

Optional 3/8" I.D. (Inside Diameter) Flexible drain tubing (See section, “Installation Instructions”)

Power Requirements

For 115 Volt Units (50/60Hz Operation)

115/60/1 dockside power Running amps: 6.9 A Starting amps: 21 A Minimum Voltage: 104 VAC Minimum Circuit: 15 A

For 220 Volt Units (50Hz Operation Only)

220/50/1 dockside power Running Amps: 3.4 A Starting Amps: 10 A Minimum Voltage: 198 VAC Minimum Circuit: 10 A

Inverter/Generator Operation

In order to use the Carry-On safely on inverter or generator power, you must confirm that the inverter/generator will be able to meet the power requirements listed in this manual. Dometic cannot assist in sizing an inverter/generator as the manufacturer of that item is best suited for that task. Damage to a unit caused by an inadequate inverter/generator is not covered under warranty.

Safe Operation of Carry-On

1.Use cord labled with LCDI or AFCI to connect to power source (see warning).

2.Using the Carry-On is not recommended while the boat is under way.

3.Prevent accidents or damage to Carry-On. Always carry or move unit using the handles. Unplug at receptacle and Carry-On control panel prior to moving.

4.Do not disassemble Carry-On.

5.Be certain the Carry-On has been properly installed according to the Installation Instructions.

6.Physical and electrical conditions vary greatly from location to location.

(a.) Be sure the electrical service is adequate and equipped with a circuit breaker (15 amps minimum for 115V units, 10 amps minimum for 220V units).

(b.) Use a three-prong (grounded) power cord rated at 15 amps minimum for 115V units or 10 amps minimum for 220V units, with a length no longer than needed to reach from the installed Carry-On to a grounded, 3-wire receptacle on your boat, or to a suitable grounded dockside outlet (order part number LCDI25).

L-2245 4 ❖ English