SERVICING YOUR TILLER
Recommended spark plugs:
NGK – CM5H or CMR5H
NOTICE
An incorrect spark plug can cause engine damage.
1.Loosen the captive 5 mm hex bolt [1] with a 4 mm Allen wrench, then remove the fan cover [2].
2.Disconnect the spark plug cap [3], and remove any dirt from around the spark plug area.
3.Remove the spark plug [4] with a
4.Inspect the spark plug. Replace it if the electrodes are worn, or if the insulator is cracked, chipped, or fouled.
5.Measure the spark plug electrode gap with a suitable gauge. Plug gap: 0.60 ~ 0.70 mm
Correct the gap, if necessary, by carefully bending the side electrode [5].
6.Make sure the sealing washer [6] is attached and install the spark plug carefully, by hand, to avoid
7.After the spark plug seats, tighten with a
If reinstalling the used spark plug, tighten
1/8 ~ 1/4 turn after the spark plug seats. If installing a new spark plug, tighten 1/2 turn after the spark plug seats.
NOTICE
A loose spark plug can overheat and damage the engine. Overtightening the spark plug can damage the threads in the cylinder head.
8.Attach the spark plug cap [3].
9.Install the fan cover [2], and tighten the 5 mm hex bolt [1] securely.
[2]
[1]
5 mm
[3] | [4] |
[5]
0.60 ~ 0.70 mm
[6]
16 | ENGLISH |