Unpacking
When unpacking, check to make sure that the product is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Installation
Note: Depending on your level of expertise, you may wish to have a qualified technician perform this installation.
Caution: Avoid damage to the Air Compressor Pump and other equipment. Make sure the mounting surface for the Air Compressor Pump is installed on a flat and level surface, strong enough to support the pump and motor.
1.Place the Air Compressor Pump on the mounting surface at the same level as the 3 HP motor used to drive it. The
2.Verify that the Belt Wheel (35) turns freely where it overhangs the mounting surface.
3.Place the
4.Pull Compressor Pump until properly aligned, and the belt is tight. Recheck motor pulley,
5.Use a pencil to mark through the Air Compressor Pump mounting holes onto the mounting surface.
6.Move the Air Compressor Pump and drill four 3/8 inch holes in the mounting surface.
7.Move the Air Compressor Pump back to its mounting position.
8.Secure each corner of the base with a 3/8 inch diameter bolt, washer, lock washer, and nut (all not supplied).
9.Make final alignment and belt tightness adjustments from the motor. It may be necessary to loosen the motor mounting bolts to adjust the motor location. To test the proper tension on the
10.Mount the motor (not supplied) as recommended by the motor manufacturer. Be sure that the motor is securely mounted.
11.Connect plumbing hardware (not supplied) from the male ½” - 14 tpi Air Outlet
(6) to the air destination (i.e., air pressure tank, not supplied).
12.Install a safety guard (not supplied) that surrounds the motor pulley,
SKU 93785 For technical questions please call | Page 6 |