Dometic SANITATION SYSTEM Toilet Model Identification, Toilet Operation, 000000, System Start-Up

Page 4
TOILET MODEL IDENTIFICATION

TOILET MODEL IDENTIFICATION

DOMETIC CORPORATION

P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886

BIG PRAIRIE, OH 44611 USA

MODEL NO. 000

SERIAL NUMBER

000000

The above label is located on the toilet base and will show the model number and serial number. If label is not available, please refer to the Dimensional Specifications section for toilet model identification.

TOILET OPERATION

IMPORTANT INFORMATION BEFORE OPERATION

1.Fill freshwater tank and add deodorant to holding tank through toilet bowl. (See System Start-Up section.)

2.Make sure all guests understand the operation of the EcoVac system and the instruction label is in plain sight and easy for guests to read. If this label is not included in this manual, please contact the SeaLand Product Customer Service Department immediately.

3.Remember the vacuum pump starts automatically. Shut off the system before servicing and do not leave the boat with toilet system breaker on.

4.Never use drain openers, alcohol, solvents, etc. in the system.

5.If the system does not function properly, refer to the Troubleshooting section of this manual and repair as necessary. If problem persists, contact your local SeaLand product dealer.

SYSTEM START-UP

1.Turn on electrical power to system.

2.Flush water into system by depressing flush lever until water starts flowing to the vacuum pump, approximately 15 seconds. This wets the pump interior for efficient operation. If vacuum pump does not run, check for loose electrical connections. Refer to the wiring diagram at the end of the Troubleshooting Guide section.

3.The vacuum pump will run for approximately 30 to 90 seconds until system reaches operating vacuum level and

then will shut off.

NORMAL OPERATION

1.To add water to the toilet before using, raise flush lever until desired water level is reached. Generally, more water is required only when flushing solids.

2.To flush toilet, press flush lever sharply down to the floor until contents clear bowl. A sharp popping noise is normal when the vacuum seal is bro- ken and flushing action begins. Be sure to hold lever down for three (3) seconds. If flush lever is accidentally released before waste clears bowl, do not attempt to flush toilet again until vacuum pump stops running. A small amount of water should remain in the bowl after flushing.

3.Do not dispose of sanitary napkins or other non-dissolving items in toilet, such as facial tissue or paper towels. These items can cause plugging of the system.

NOTE: Make sure all guests understand the operation of the EcoVac toilet, and that the instruction label is easy to read and in plain sight.

4

Image 4
Contents SANITATION SYSTEM ECOVACDometic Corporation SeaLand TABLE OF CONTENTS PRODUCT FEATURESBacked by the Best in Service and Quality Freshwater FlushKEY SYSTEM COMPONENTS VACUUM HOLDING TANK SYSTEMTOILET MODEL IDENTIFICATION TOILET OPERATION000000 DOMETIC CORPORATIONPROPER CLEANING WINTERIZINGCONVENIENCE PRODUCTS To drainMAINTENANCE SERVICE TIPORDERING PARTS VACUUM TESTERTROUBLESHOOTING GUIDE BASE ASSEMBLYProblem Service InstructionsTROUBLESHOOTING GUIDE cont’d ProblemService Instructions Possible CauseTROUBLESHOOTING GUIDE cont’d ProblemService Instructions Possible CauseDIMENSIONAL SPECIFICATIONS PARTS LISTECOVAC TOILET ECOVACPARTS LIST cont’d VACUUM GENERATORDescription DescriptionVACUUM HOLDING TANK PARTS LIST cont’dDescription DescriptionVACUUM PUMP VACUUM TANKVACUUM PUMP VACUUM TANK PARTS LIST cont’dWIRING DIAGRAMS VACUUM PUMP VACUUM GENERATOR VACUUM HOLDING TANKU.S.A MASTER SANITATION DISTRIBUTORS PARTS DISTRIBUTORSINTERNATIONAL DISTRIBUTORS MANUFACTURER’S ONE-YEARLIMITED WARRANTY EXCLUSIONSIMPLIED WARRANTIES OTHER RIGHTS