Adjusting Depth of Cut
1.Loosen the Screw (71) and move Depth Stop to rear (away from blade) to make deeper cut. After making adjustment
Bevel Stop to 90 Degrees
Depth Stop (71) hidden from view
1.Position saw bevel stop at 90 degrees and loosen bevel Adjusting Handle (73).
2.Tilt cutting arm all the way up to 90 degrees position on the Scale and retighten Adjusting Handle.
3.Lower the cutting head and place a Square on the surface of the Blade and the left side of the Table.
4.Loosen Lock Nut and turn Screw (A) until the Saw Blade touches the Left Kerf Plate and is at 90 degrees to Table. Retighten Lock Nut.
Screw and Lock Nut (A)
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU- TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 45885 | Page 10 | REV 05/03 |
45885.p65 | 10 | 10/15/03, 10:41 AM |