Harbor Freight Tools 47003 operating instructions See Figure G, See Figures G and H

6.	Use the 8mm Hex Wrench (76) to	FIGURE F
	remove the Screw (60).
	NOTE: Make sure to turn the Screw
	counterclockwise to remove.
	(See Figure G.)

7.Remove the Small Flange (59). Then, remove the Outer Flange (58).

(See Figures G and H.)

8.	Remove the old Cut-Off Wheel (57),			LOCK PIN
				(40)
	and replace it with a new Cut-Off
	Wheel.
		CAUTION!	Use a 14” diameter
		Cut-Off Wheel with a 1” round Arbor
	hole, and rated at a minimum of 4,000
	RPM. Cut-Off Wheels that do not
	match the mounting hardware of the
	Saw or that are rated at less than the
	saw’s maximum RPM may fly off the Saw or may run eccentrically, causing loss of
	control.

8mm

HEX WRENCH

(76)

SCREW

(60)

FIGURE G

SMALL

FLANGE

(59)

SCREW

(60)

OUTER

FLANGE

(58)

FIGURE H

9.Reinstall the Outer Flange (58) (with the concave side facing the Wheel), Small Flange (59), and Screw (60). NOTE: Make sure to firmly tighten the Screw in a clockwise direction while depressing the Lock Pin (40). (See Figures G and H.)

10.Reinstall the Swing Guard (61), and secure it in place with the Guard Retainer Screw (62). Make sure to tighten the Screw in the screw hole referred to in

Figure D. (See Figures D and E.)

SKU 47003 PAGE 12