ASSEMBLY INSTRUCTIONS
Mounting Scroll Saw to Workbench
1.Pick a solid, wood workbench to mount the saw. The workbench must be stable, and able to support the weight of the Scroll Saw and the material being cut.
2.Find the four 5/16 inch mounting holes in the Base (9) and mark through the holes for drilling with a 3/8 inch drill bit. Remove Scroll Saw to drill holes.
3.Replace Scroll Saw over holes and mount with the following hardware (not supplied): 4 - Hex Head Screws, 1/4 inch x 20 x length required; 4 - Flat Washers, 9/32 I.D.; 4- Lock Washers, 9/32 I.D.; and
4.Check that all Scroll Saw screws and nuts are tight before using the machine.
Check and Align Bevel Indicator
1.Loosen Table Lock Knob (44) and move the table until it is approximately perpendicular (right angle) to the blade. See photo below.
2.Use a small combination square to set the table at 90 degrees to the blade.
3.Tighten the Table Lock Knob (44).
4.Loosen Pan Screw (14) holding the bevel Scale Indicator (13), and adjust Indicator to point to “0” degrees. Retighten Pan Screw.
Note: The bevel Scale Indicator (13) is a guide and should not be relied upon for preci- sion settings. Make practice cuts in scrap wood to determine if the angle settings are correct.
OPERATING INSTRUCTIONS
Controls and Indicators
Workpiece Foot Lock
Knob (68)
Workpiece Foot (48)
Bevel Scale (15)
Scale Indicator (13)
Table Lock Knob (44)
Vacuum Hose Connection
Blade Tension Knob (21)
Saw Table (53)
Variable Speed Knob (81)
On / Off Switch (72) with
Locking Key
REV 05/05
SKU 93012 | For technical questions, please call | Page 9 |