32.Allow the Saw Blade to spin up to full speed before feeding a workpiece into it. When turning off the Tile Saw, allow the Saw Blade to spin down and stop on its own. Do not press against the Saw Blade to stop it.
33.Do not force the workpiece into the Saw Blade when cutting. Apply moder- ate pressure, allowing the Saw Blade to cut without being forced.
34.Turn off the Tile Saw and allow the Saw Blade to stop on its own if the Saw Blade is to be backed out of an uncompleted cut.
35.Never attempt to remove material stuck in the moving parts of the Tile Saw while it is plugged in and running.
36.When cutting a large workpiece make sure its entire length is properly supported. If necessary, use a roller stand (not included) with larger workpieces.
37.Never stand on the Tile Saw. Serious injury could result if the Tile Saw is tipped or if the rotating Saw Blade is accidently contacted.
38.Industrial applications must follow OSHA requirements.
39.For your safety: In extreme working conditions, sensors in the Tile Saw will automatically switch off the Motor to prevent overheating. In this event, turn the Power Switch to its “OFF” position. Wait five minutes or until the Motor has cooled. Making sure your hands are dry, depress the Circuit Breaker. Then, turn the Power Switch to its “ON” position to resume cutting. NEVER attempt to disable the Circuit Breaker.
40.Never attempt to cut more than one tile at a time.
41.Never attempt to cut freehand. Make sure the tile to be cut is pressed firmly against the Rip Fence.
42.Never cut pieces too small to be held securely against the Rip Fence with out leaving enough space for the hand to be a safe distance from the Saw Blade.
43.Make sure the tile to be cut has sufficient room to move sideways. Failure to do so may result in the tile binding against the Saw Blade.
44.Make sure the Table and surrounding area are clear with the exception of the tile to be cut.
SKU 92658 For technical questions, please call | Page 8 |