Harbor Freight Tools 42818 operating instructions Maintenance, Replacing the Motor Brushes

Page 10

Shaft Lock Button

Hex Flange Bolt (83)

Socket Wrench

7.Remove the existing Saw Blade and replace with another 12 inch blade.

The new Saw Blade has an arrow on it that must be pointing in the same direction as the large arrow on the outside of the Blade Case (31).

Caution: Never use saw blades larger or smaller in diameter than 12 inches, and rated less than 5000 RPM operation.

8.Replace the Outer Flange (82) and Hex Flange Bolt (83).

9.Press in on the Spindle Lock button and retighten the Bolt in a counterclockwise direction with the socket wrench.

10.Replace the Safety Cover to its original position and retighten the Hex Bolt (A).

11.Press down on the saw Handle and verify that the safety Shield moves back properly, and that the blade does not touch the Fence or Table.

Maintenance

Replacing the Motor Brushes

It may become necessary at sometime to replace the motor brushes when the motor perfor- mance decreases, or stops working completely. The following steps describe their replace- ment. This procedure should be done by a qualified technician.

1.Unplug the Power Cord Plug from the electrical outlet.

2.Remove the Brush Holder Caps (14) and Carbon Brushes (13) from the Motor Housing (16).

Examine the Carbon Brushes. If the they are worn past 3/16 inch in length, or if the spring or shunt wires are burnt, they must be replaced. Never replace just one brush. If the brushes are only dirty, and not worn down, you can use a pencil eraser to clean the brush tips.

3.Replace the Carbon Brushes (13) and Brush Holder Caps (14) .

4.Connect the Power Cord to an electrical outlet and test the saw’s operation.

SKU 42818

Page 10

Image 10
Contents For technical questions and replacement parts, please call 42818Read all instructions before using this tool SpecificationsSafety Warnings and Precautions Save This ManualPage Safety Precautions when using a Compound Slide Miter Saw Unpacking InstallationOperation Auxiliary Wood Fence Positioning the Kerf BoardsPreparation to Cut Stock Cutting Stock Slide CuttingReplacing the Saw Blade Maintenance Replacing the Motor BrushesSaw Blade Perpendicular to Fence AdjustmentsGeneral Maintenance Downward Travel of the Saw BladeBevel Stop to 90 Degrees Please Read the Following CarefullyParts List REV 11/02 REV 05/04Assembly Drawing REV 05/04