Cutting Stock
1.Plug the Power Cord into the electrical outlet.
2.With the workpiece secure, turn on the saw by pressing down on the
Handle (65)
Brush Holder Cap (14)
Switch (70) Trigger Button
Dust Collection Bag
Slide Pipe (44)
Safety Cover (88)
Knob Screw (105)
Arm Release Button
Bevel Knob (146)
Fence
Lever Rod (156)
Kerf Boards (121 & 118)
Bevel Scale
Handle Grip (128)
Vertical Clamp
Miter Scale
3.When the Saw Blade comes to full speed, bring the Saw Blade down and begin cutting slowly through the stock without stopping.
Warning: Avoid personal injury. Do not disable the Saw Blade Safety Cover (88). Keep fingers and hands away from the moving blade.
4.When the cut is finished, release the Switch (70) trigger button.
Wait for the Saw Blade to stop turning before reaching for the cut stock.
5.When you are finished using the saw, press the cutting head down until it locks into position.
6.Unplug the Power Cord from the electrical outlet.
7.Pull out the
Slide Cutting
To cut larger pieces of stock, follow these steps.
1.Secure the workpiece to the table and fence.
2.Loosen the Knob Screw (105) so that the carriage can slide freely.
3.Raise the cutting arm by pushing down slightly on the Handle, then pulling out the Arm Release Button.
SKU 42818 | Page 8 |