Unpacking

When unpacking, check to make sure all the parts shown on the Parts List on page 16 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE:

For additional references to the parts mentioned in the

following pages, refer to the Assembly Diagram on page 17.

To Permanently Mount The Tile Saw On A Workbench:

1.WARNING! Make sure the Power Switch (21) of the Tile Saw is in its “OFF” position and its Power Cord/Plug (34) is unplugged from the electri- cal outlet prior to performing any assembly.

2.The Tile Saw may be temporarily placed upon a workbench for use. Also, the Tile Saw may be permanently mounted on a workbench.

3.CAUTION! Make sure the workbench on which the Tile Saw will be tempo- rarily or permanently used is flat, level, and sturdy enough to support the weight of the Tile Saw, any workpieces, and any additional tools.

4.To permanently mount the Tile Saw on a workbench, place the Tile Saw in the desired work location on the workbench. Use the four 7/16” wide x 3-1/2” long mounting slots at the base of the Inner Cover (16) as a template to mark the areas where four 7/16” diameter mounting holes should be drilled through the workbench.

5.Temporarily remove the Tile Saw, and drill the four 7/16” diameter mounting holes through the workbench, making sure no hidden electric cords or cables are in the drilling path.

6.Once the mounting holes are drilled, align the four 7/16” wide x 3-1/2” long mounting slots in the base of the Inner Cover (16) with the four predrilled mount- ing holes in the workbench. Secure the Tile Saw to the workbench, using four appropriate length Bolts, Lock Washers, and Nuts (not included).

SKU 40315

For technical questions, please call 1-800-444-3353.

Page 12