Harbor Freight Tools 42307 operating instructions OperationCutting, Setting the Vise

Page 8

Safety

Switch (6)

Belt Cover (7)

Lever (27)

 

 

Figure 1

Handle (8)

 

 

 

 

 

Arrow on Blade Guard

Blade Guard (21)

Vise Fixture (22)

Vise Jaw (25)

 

 

Vise Handle (11)

 

Mounting Holes

 

 

 

OperationCutting

When operating your Mini Cut-Off Saw, it will be helpful to refer to Figure 1 as well as to the Parts List and Assembly Diagram near the end of this manual.

Setting the Vise

1.The Miter Gauge on the Vise (9) can be set from 0°- 45°. Loosen the Vise Fixture (22) and slide the Gauge to the desired angle. Tighten the Vise Fixture into place.

2.The Vise Jaw (25) can be adjusted for the work piece with the Vise Handle (11). Turning the Vise Handle (11) clockwise will tighten the Vise Jaw(s) onto the workpiece. Turning the Vise Handle counterclockwise will loosen the Vise Jaw.

1.Place the material to be cut in the Vise (9) as described above.

2.The Mini Cut-Off Saw has a Safety Lever (27) which must be released to lower the Blade. Pushing down on the Safety Lever (27) will release the Safety Lever, allowing you to push down on the Handle (8) to begin cut- ting.

3.Turn the Saw “ON” by pressing down on the red Switch (6) on the side marked with . To turn the Saw “Off”, press down on the end of the Switch (6) marked O.

4.With the Saw at full speed, move it slowly forward to complete the cut.

5.When the cut is complete, pull up on the Handle (8). The Safety Lever

(27)will engage. Turn the Saw “Off”.

6.Store out of reach of children.

REV 10a

SKU 42307

For technical questions, please call 1-800-444-3353.

Page 8

Image 8
Contents For technical questions or replacement parts, please call Bench TOP CUT-OFF SAWGeneral Tool Safety Warnings Save This ManualSave all warnings and instructions for future reference For technical questions, please call25’ 50’ 100’ 150’ Table aOutlets for 2-Prong Plug Miter Saw Safety WarningsGrounding Instructions Vibration Safety For technical questions, please call Specifications AssemblyInstalling the Cutting Blade UnpackingSetting the Vise OperationCuttingMaintenance Servicing Cleaning, Maintenance, LubricationParts List Part Description QtyAssembly Diagram Limited 90 DAY Warranty