Festool KA-KS 120 Trimming attachment, Scope of delivery, Preparations, Leg support plate, Set-up

Trimming attachment KA-KS 120

1 Scope of delivery

The trimming attachment consists of the following main components:

(1.1) Stop profile

(1.2) Tape measure clamp

(1.3) Support

(1.4) Support plate

(1.5) Stop flag

(1.6) Adjustable spacer

(1.7) Extendable end piece

(1.8) Leg support plate

(1.9) Tape measure

2 x KA-KS 120 right

left

(1.13) Cross brace								2.1 Preparations
1.9	1.8	1.7	1.6	1.5 1.4	1.3	1.2	1.1
								–Secure the KS 120 to a Festool multifunc-
								tion table (MFT) or a work bench with a
								height of 31.1 in./790 mm (see operating
								manual KS 120).

		2.2 Leg support plate
1.10 1.11 1.12	1.13	The leg support plate (1.8) is designed to
		support the trimming attachment and is
		fixed to the extendable end piece (1.7).
		3.6	3.7

1

2	Set-up		3.5
When setting up the attachment, proceed in			3.4
the sequence specified.
Important: you will require a crown mould-			3.1
ing stop (AB-KS 120) to make the connec-				3.8
			3.3
tion to the KS 120.
Refer to Figure 1 for the arrangement and
positioning of the individual parts.
Fig. 1 shows a rear view of the trimming			3.2
attachment.		3
The following section describes how to attach
the right trimming attachment. Use the		–Unscrew both rotary knobs (3.1) until the
same procedure to attach the left trimming		two support legs (3.3) can be inserted into
attachment! Fig. 2 shows the stop mounted		the clamping sleeves (3.4).
on both sides!		–Insert the support legs until the leg sup-
		port plate reaches the same height as your

KS 120.

–Tighten the rotary knobs (3.1) to clamp the support legs in place.

–Screw the rotary knob (3.2) through the recess (3.5) and into the slot nut (3.8) in the bottom slot (3.7) on the extendable

2