11.1 11.2
11 |
|
|
|
|
|
| |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
11.4 | 11.3 | ||||||
11.5 | |||||||
–Set both the horizontal and vertical mitre angles on the KS 120 to 0°.
–Place a workpiece (11.4) with a length of 18.72 in./450 mm on the KS 120 lengthways against the saw blade (11.3).
–Slide the stop flag (11.1) up to the workpi- ece. Clamp the stop flag in this position.
–Unscrew the rotary knob for the measuring tape clamp (11.5).
–Move the tape measure until the measure- ment at the edge (11.2) of the stop flag indicates 18.72 in./450 mm.
–Use the tape measure clamp (11.5) to se- cure the tape measure in this position. The tape measure now indicates the exact dis- tance to the saw blade. The measurement at the edge (11.2) is the distance between the stop flag and the saw blade.
3.2Length adjustment
Unscrew the rotary knob (1.12) to extend and retract the end piece (1.7). The maximum extension length is 90.55 in./2300 mm.
Unscrew the rotary knob (1.11) to move the spacer.
4 Working
To trim a workpiece to a certain length, pro- ceed as follows:
–Adjust the stop flag to the required dimen- sion.
–Place the workpiece against the stop flag.
–Cut through the workpiece with the KS 120.
5