Panasonic CR-W402UA Follow the instruction to install and wire the product, Installation Angle

Page 3

Caution

Observe the following cautions when handling this unit.

Keep the sound volume at an appropriate level.

Keep the volume level low enough to be aware of road and traffic conditions while driving.

This unit is designed for use exclusively in automobiles.

Do not operate the unit for a prolonged period with the engine turned off.

Operating the audio system for a long period of time with the engine turned off will drain the battery.

To ensure safety, never attempt to preset stations while you are driving.

Depending upon the transmission condition of electro-magnetic waves, the geographical reasons and/or the weather conditions, you may not receive the NOAA radio partially or at all.

Make sure that your weather radio can receive properly before driving, especially, before use in a critical condition.

Observe the following cautions when installation.

Refer wiring and installation to qualified service personnel.

Installation of this unit requires special skills and experience. For maximum safety, have it installed by the shop where you purchased it. Panasonic is not liable for any problems resulting from your own installation of the unit.

Follow the instruction to install and wire the product.

Not following the instructions to properly install and wire the product could cause an accident or fire.

Take care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.

Use the designated parts and tools for installation.

Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunction or fire.

Do not block the air vent or the cooling plate of the unit.

Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.

Do not install the product where it is exposed to strong vibrations or is unstable.

Avoid slanted o strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.

Installation Angle

The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚. The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details.

Wear gloves for safety. Make sure that wiring is completed before installation.

To prevent damage to the unit, do not connect the power connector until the whole wiring is completed.

Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

The following applies only in the U.S.A.

Part 15 of the FCC Rules

FCC Warning:

This device complies with Part 15 of the FCC Rules for Radio Receiver. Operation is subject to the condition that this device may not cause harmful interference. Any unauthorized changes or modifications to this equipment may void the user's authority to operate this device.

Accessories

1.

Operating Instructions

1

2.

Supplied Hardware

1 set (a page 18)

 

3.

Product Registration Card

1

 

4.

Customer Care Plan

1

3

CR-W402UA

Image 3
Contents Model CR-W402UA Do not expose the unit to direct sunlight or excessive heat Safety InformationUse the proper power supply Do not use the unit when it is out of orderTake care not to damage the leads Follow the instruction to install and wire the productUse the designated parts and tools for installation Installation AngleCustomer Services Directory United States and Puerto Rico Customer Services DirectoryLimited Warranty For USA and Puerto Rico Only Limited WarrantyContents Display Change Power and Sound ControlsPower VolumeSQ Sound Quality Push Audio Modes Bass/Treble/Balance/FaderInitial Time Clock AdjustmentTime Readjustment Selecting the Clock DisplayBand Manual TuningSeek Tuning RadioPreset Station Calling Preset Station SettingAuto Preset Memory APM Manual Preset MemoryWeather Band Stations Tuning in a Weather Band StationTroubleshooting Troubleshooting Tips CommonRadio Sound Setting AConnect the speaker wires to the correct onesProduct Servicing Maintenance Speaker ConnectionsChassis Please refer to the Warning statement above Installation GuideDashboard Specifications OverviewInstallation Hardware InstallationPrecautions Dashboard InstallationTo Remove the Unit from the vehicle’s dashboard Mounting springs CExample Electrical Connections Wiring DiagramAM Radio SpecificationsGeneral FM Stereo RadioMemo Memo Panasonic Corporation YFM264C170CA PTW0808