899604 -
INSTALLING THE QUICK RELEASE DRUM SYSTEM
CAUTION: DISCONNECT TOOL FROM POWER SOURCE. The quick release drum system is easy to assemble and convenient to use. Fig. 1.
Note: When installing a 1/2" sanding sleeve onto the shaft, do not use the rubber drum (B) or washers (A) Fig. 1.
1.Place washer (A) onto the spindle shaft.
2.Place rubber drum (B) onto the spindle shaft.
3.Place second washer (A) over the bolt hole opening.
4.Thread
A
B
A
C
D
Fig. 1
5.Slide sanding sleeve (D) over the rubber drum (B); (make sure the sanding sleeve (D) is flush with the rubber drum (B).)
6.Now tighten the
THE DUST COLLECTION
NOZZLE
The Model 121 sander can be operated with or without the dust collection nozzle. The dust collection nozzle can be attached to the 121 sander as shown in Fig. 2 using the two knob screws provided. A standard 1" vacuum hose can be attached to the dust nozzle to provide a means for connecting the machine to your vacuum cleaner or dust collection system.
TO START AND STOP THE 121 | Fig. 2 |
| |
OSCILLATING SANDER |
|
| |
1. Make sure the switch is in the off |
|
position, and the power circuit voltage |
|
is the same as the voltage shown on |
|
the specification plate on the sander. |
|
Connect machine to power circuit. |
|
2. Hold the machine as shown in |
|
Fig. 3, with the sander base in contact |
|
with a stable and secure workpiece, |
|
and turn the machine on with the |
|
power switch (A) Fig. 4. |
|
3. To turn off machine, move the |
|
switch (A) Fig. 4, to the off position. |
|
|
|
| Fig. 3 |
7