Porter-Cable D26126-024-0 instruction manual Storage

Page 17

STORAGE

Before you store the air compressor, make sure you do the following:

1.Review the "Maintenance" section on the preceding pages and perform scheduled maintenance as necessary.

2.Set the On/Auto/Off lever to “OFF”.

3.Turn the regulator counterclockwise and set the outlet pressure to zero.

4.Remove the air tool or accessory.

5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.

6.Drain water from air tank by opening drain valve on bottom of tank.

Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air

tank rupture.

7.After the water has been drained, close the drain or drain valve.

NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.

8.Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them loosely around the compressor handle. (If so equipped)

Store the air compressor in a clean and dry location.

17 - ENG

D26126

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Pancake Compressor Safety Guidelines Definitions Risk of Explosion or Fire HazardRisk from Flying Objects Risk of BurstingRisk to Breathing Risk of Electrical ShockRisk of Falling Risk of BurnsRisk from Moving Parts Hazard Risk of Unsafe Operation Duty Cycle GlossaryModel no CF2600Improper Grounding can Result in Electrical Location of the Air CompressorGrounding Instructions Voltage and Circuit Protection Extension CordsDescription of Operation Description of OperationKnow Your Air Compressor Before First Start-up How to StopBefore Each Start-Up How to StartTo Check Safety Valve MaintenanceCustomer Responsibilities To Drain TankTo Replace or Clean Check Valve Service and AdjustmentsTo Replace Regulator Storage Limited Warranty
Top Page Image Contents