Porter-Cable C7510 Accessories, Tools Required for Assembly, Unpacking, To Add Oil To Pump

Page 9

ACCESSORIES

Accessories for this unit are available at the store the unit was purchased.

ASSEMBLY

Tools Required for Assembly

1 - 9/16” socket or open end wrench

1 - electric drill

Unpacking

1.Remove all packaging.

It may be necessary to brace or support one side of the outfit when removing the pallet because the air

compressor will have a tendency to tip.

2.Remove and discard the (4) screws and washers holding the compressor to the pallet.

3.With the help of another person carefully remove air compressor from pallet and place on a level surface.

To Add Oil To Pump

Compressors are shipped without oil in the crankcase. A small amount of oil may be present in the pump upon

receipt of the air compressor. This is due to plant testing and does not mean the pump contains oil. Do not attempt to operate this air compressor without first adding oil to the crankcase. Serious damage can result from even limited operation unless filled with oil and broken in correctly. Make sure to closely follow initial start-up procedures.

Multi-Viscosity motor oils, like 10W 30, should not be used in an air compressor. They leave carbon deposits on

critical components, thus reducing performance and compressor life. Use air compressor oil only.

NOTE: Oil is included with some units. If oil is not included, use an oil specifically formulated for use in an air compressor, such as Porter-Cable PAS1 air compressor oil. Oil may be found at the store where the air compressor was purchased.

1.Place unit on a level surface.

Drain tank to release air pressure before removing the oil fill cap or oil drain plug.

2.Remove oil fill plug (A) and slowly add compressor oil until it reaches the middle of the sight glass (B).

NOTE: When filling the crankcase, the oil flows very slowly into the pump. If the oil is added too quickly, it will overflow and appear to be full. NOTE: Crankcase oil capacity is approximately 29 fluid ounces.

3.Replace oil fill plug.

A

B

9- ENG

D28176

Page 8 Page 10
Image 9
Page 8 Page 10
Contents C7510 ModelImportant Safety Instructions Safety Guidelines DefinitionsHazard Attachments & Accessories Electricity. Like any other electrically Result in serious burns Fire, Inhalation, Damage to Vehicle Surfaces Specifications GlossaryDuty Cycle Assembly AccessoriesTools Required for Assembly UnpackingInstallation Location of the Air CompressorAnchoring of the Air Compressor Grounding Instructions Wiring InstructionsAir Distribution System Know Your Air Compressor Description of Operation OperationHow to Use Your Unit Before Starting Break-in ProcedureHow to Stop Before Each Start-Up How to StartMaintenance To Check Safety ValveCustomer Responsibilities Oil To Drain TankChecking ChangingBelt Replacement Air Filter Inspection and ReplacementAdjusting Belt Tension Belt Guard RemovalMotor Pulley/Flywheel Alignment Air Compressor Pump Intake and Exhaust Valves Inspect Air Lines and Fittings for LeaksAir compressor Head Bolts Torquing To Replace or Clean Check Valve Service and AdjustmentsAdditional Service StorageMotor Problem Cause Correction TroubleshootingProlonged excessive use Problem Cause Correction Problem Cause Correction ENG D28176 Limited Warranty
Top Page Image Contents