A
Fig. 4
MOVING CUTTINGHEAD
TO THE REAR POSITION
1.MAKE CERTAIN THE MACHINE IS DISCON- NECTED FROM THE POWER SOURCE.
2.Carefully remove cable tie (A) Fig. 4, which is holding the cuttinghead in the down position.
3.To move the cuttinghead (D) Fig. 5, to the rear position, loosen lock knob (E) and push cuttinghead (D) to the rear position. Then tighten lock knob (E) Fig. 6.
4.Fig. 6, illustrates the cuttinghead locked in the rear position.
RAISING THE CUTTINGHEAD
1.While holding the cuttinghead (A) Fig. 7, down, pull out and rotate cuttinghead lock knob (B) 90 degrees until pin (C) Fig. 8, is in the horizontal position as shown. The cuttinghead can then be raised.
2.Fig. 9 illustrates the cuttinghead (A) in the raised position.
3.W ARNING: Cutterhead lock knob (B) Fig. 7, is designed to lock the cutterhead in the down position for only storage or carrying. Never operate saw with the cutterhead in the lock down position.
C
B
Fig. 8
E
D
Fig. 5
E 
Fig. 6
A
B
Fig. 7
A
Fig. 9
6