Porter-Cable 3807 instruction manual Assembly, Assembling Dust Elbow and Dust BAG

ASSEMBLY

W ARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ A N D UNDERSTOOD THE ENTIRE OWNER S MANUAL.

A

DC

A

B

Fig. 10 Fig. 11

ASSEMBLING DUST ELBOW AND DUST BAG

1.Insert smooth end of dust elbow (A) Fig. 10, into opening (B). The dust elbow (A) can be rotated as desired.

2.Compress spring clips (C) Fig. 11, on dust bag (D) and clip dust bag onto end of elbow (A) as shown.

MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION

1.Rotate locking knob (A) Fig. 12, counterclockwise to unlock. Depress lever (B) and rotatetable (C) to the 0 degree straight cut-off position, release lever (B) and tighten locking knob (A).

2.Fig. 13, illustrates the table (C) in the 0 degree straight cut-off position.

3. For proper operation and adjustment of the table, refer to sections,		ROTATING	TABLE	FOR MITER
CUTTING , ADJUSTING CLAMPING ACTION	OF TABLE LOCKING	MECHANISM	and	ADJUSTING
SLIDING FIT BETWEEN MOVABLE TABLE AND	BASE.

C

A

C

B

Fig. 12 Fig. 13

7