Porter-Cable 3700L instruction manual PORTER-CABLE Limited ONE Year Warranty

Page 22

WARRANTY

PORTER-CABLE LIMITED

ONE YEAR WARRANTY

Porter-Cable warrants its Professional Power Tools for a period of one year from the date of original purchase. We will repair or replace at our option, any part or parts of the product and accessories covered under this warranty which, after examination, proves to be defective in workmanship or material during the warranty period. For repair or replacement return the complete tool or accessory, transportation prepaid, to your nearest Porter-Cable Service Center or Authorized Service Station. Proof of purchase may be required. This warranty does not apply to repair or replacement required due to misuse, abuse, normal wear and tear or repairs attempted or made by other than our Service Centers or Authorized Service Stations.

ANY IMPLIED WARRANTY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WILL LAST ONLY FOR ONE (1) YEAR FROM THE DATE OF PURCHASE.

To obtain information on warranty performance please write to: PORTER-CABLE CORPORATION, 4825 Highway 45 North, Jackson, Tennessee 38305; Attention: Product Service. THE FOREGOING OBLIGATION IS PORTER-CABLE’S SOLE LIABILITY UNDER THIS OR ANY IMPLIED WARRANTY AND UNDER NO CIRCUMSTANCES SHALL PORTER-CABLE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Manual Español Página FrançaiseTable of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsNever Recut Small Pieces Additional Safety Rules for Miter SawsAdditional Safety Rules for the Laser Do not Perform FREE-HAND OperationsMotor Specifications Power ConnectionsGrounding Instructions Carton Contents Functional DescriptionAssembly Tools Required AssemblyUnpacking and Cleaning Assembly Time EstimateAttaching Extension Table and Fence Slide Attaching the Dust BAG Locking Switch in the OFF PositionOperation Fastening Machine to Supporting SurfacePositive Stops Disconnect the Machine from the Power Source Adjusting the Fence 90 to the BladeDisconnect the Machine from Power Source Rotating the Table for Miter CuttingTilting Cuttinghead for Bevel Cutting Adjusting Sliding FenceTable Hazard Zone Adjusting Sliding FIT Between Cuttinghead ARM and Trunnion Adjusting the Tension of Cuttinghead Return SpringAdjusting 0 and 45 Bevel Positive Stops HOW to Check Laser Alignment Adjusting Downward Travel of SAW BladeLaser USE and Adjustment HOW the Lasers WorkTo Check for Rotational Alignment To Check for Vertical AlignmentAdjusting Lower Blade Guard Typical Operations and Helpful HintsAuxiliary Wood Fence General Cutting OperationsRight Cutting AluminumCutting Bowed Material WrongCrown Moulding Other Angles Cutting Crown MouldingDisconnect Machine from Power Source Troubleshooting MaintenanceChanging the Blade Service AccessoriesWarranty PORTER-CABLE Limited ONE Year WarrantyCanadian PORTER-CABLE Delta Service Centers
Top Page Image Contents