ASSEMBLY INSTRUCTIONS
ASSEMBLING BLADE RAISING AND LOWERING HANDWHEEL
1.Insert the
(E). Assemble handle (E) to handwheel (A) by threading screw (D) clockwise into handwheel as shown in Fig. 5. Handle (E) should rotate freely on screw (D).
E
D
Fig. 4
E
D
A
Fig. 5
ASSEMBLING BLADE GUARD AND SPREADER ASSEMBLY
1. WARNING: WHEN ASSEMBLING THE BLADE GUARD AND SPREADER ASSEMBLY, MAKE CERTAIN THE SAW IS DISCONNECTED FROM THE POWER SOURCE.
2. IMPORTANT: THE BLADE GUARD AND SPREADER
ASSEMBLY MUST BE PROPERLY ALIGNED TO THE SAW BLADE IN ORDER TO HELP PREVENT KICKBACK.
3.Position the blade 90 degrees to the table and lock in place.
4.Insert spreader end (A) Fig. 6, of blade guard into anchor block (B). Push spreader (A) down into holder until you hear a click, indicating that the spreader is secured. NOTE: It is important that the spreader (A) be in the vertical position and pushed straight down into the spreader anchor block (B) during the assembly procedure.
5.Fig. 7 illustrates the blade guard in place.
A
B
Fig. 6
Fig. 7
4