Replacement Parts, Motor | Porter-Cable 324MAG, 325MAG instruction

SYMBOL	DEFINITION
V	volts
A	amperes
Hz	hertz
W	watts
kW	kilowatts
µF	microfarads
l	liters
kg	kilograms
N/cm2	newtons per square centimeter
Pa	pascals
h	hours
min	minutes
s	seconds
........................	alternating current
3	three-phase alternating current
3N	three-phase alternating current with neutral
........................	direct current
n0	no load speed
........................	alternating or direct current
.......................	Class II Construction
........................	splash-proof construction
........................	watertight construction
…/min	revolutions or reciprocation per minute

REPLACEMENT PARTS

When servicing use only identical replacement parts.

MOTOR

Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60 cycle A.C. current and voltage within plus or minus 5 percent of that shown on the specification plate on the tool. Several models, however, are designed for A.C. current only. Refer to the specification plate on your tool for proper voltage and current rating.

Do not operate your tool on a current on which the voltage is not within correct limits. Do not operate tools rated A.C. only on D.C. current. To do so may seriously damage the tool.

EXTENSION CORD SELECTION

If an extension cord is used, make sure the conductor size is large enough to prevent excessive voltage drop which will cause loss of power and possible motor damage. A table of recommended extension cord sizes will be found in this section. This table is based on limiting line voltage drop to 5 volts (10 volts for 230 volts) at 150% of rated amperes.

If an extension cord is to be used outdoors it must be marked with the suffix W-A or W following the cord type designation. For example – SJTW-A to indicate it is acceptable for outdoor use.

SYMBOL

DEFINITION