Improper connection of the equipment- grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment- grounding connector.
If repair or replacement of the electric cord or plug is necessary, do not connect the
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded.
Use only
Repair or replace damaged or worn cord immediately.
115 Volt Operation
As received from the factory, your drill press is ready to operate at
A temporary adapter, similar to the one in Figure 12, may be used to connect this plug to a
The
230 Volt Operation
If 230V, single phase operation is desired, the following instructions must be performed:
1.Disconnect the machine from the power source.
2.The drill press motor has four leads that are factory connected for 115V operation. For 230V operation,
3.The 115V attachment plug supplied with the drill press must be replaced with a UL/CSA listed plug suitable for 230V operation, similar to the plug illustrated in Figure 13. Contact your local Authorized Powermatic Service Center or qualified electrician for proper procedures to install the plug.
Figure 11
Figure 12
Figure 13
11