Unpacking, Contents of the Shipping Container

Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Drill Press is assembled and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

1Column Assembly with Rack and Ring

1Head Assembly

1Base

1Table Bracket and Table

The smaller accessories are shown in Figure 1:

3Downfeed Handles (A)

1Chuck (B)

1Drift Key (C)

1Arbor (D)

1Shift Knob (E)

1Locking Handle (F)

2Lock Knobs (G)

2T-Nuts (G)

2Flat Washers (G)

2Socket Head Cap Screws, M6x12 (G)

2Hex Nuts, M6 (G)

1Worm (H)

1Large Handle (I)

4Hex Cap Screws, M10x40 (J)

3Hex Wrenches, 3,5 and 6mm (K)

1Dust Port (L)

1Fence Assembly (M)

1Owner's Manual (not shown)

1Warranty Card (not shown)

Figure 1

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.