Powermatic 2000 operating instructions Insert Adjustment, Arbor and Arbor Bearing Removal

Page 19

Note: These screws are accessible through openings on the floating clamp block (B) located diagonally on either side of the lock handle (A). They secure the fixed clamp block (C) to the riving knife extension plate (F).

Loosening these screws (E) will allow the fixed clamp block (C) to slide back and forth on the extension plate (F).

3.Slide the fixed clamp block (F) toward or away from the saw blade as required.

4.Tighten the socket head button screws (E).

5.Reinsert the riving knife; tighten the lock handle (A, Fig. 18) and check that the saw blade/knife gap is between 3 - 8mm (Figure 20).

Note: Attempt to make the gaps as even as possible.

Insert Adjustment

Adjust the setscrews in the insert with a 3mm hex wrench (Figure 21) to ensure that the insert is stable and flush with the table top.

Arbor and Arbor Bearing Removal

The saw arbor is press fit in the saw raising arm housing. If the arbor needs to be removed for bearing replacement, it should be done by a qualified service technician. Call your customer service representative at the phone number on the front cover.

Figure 20

Figure 21

19

Image 19
Contents Inch Cabinet Saw Warranty and Service Table of Contents Page Page Introduction Specifications Shipping Contents Contents of the Shipping Container Extension Tables Mounting Extension Wings AssemblyDust Chute Lock Knobs and Swivel HandlesMotor Cover Blade Installation/ReplacementDescription Riving Knife and Guard InstallationExtension Cords AdjustmentsHandwheel Adjustments Grounding InstructionsCastor system adjustment Zero-Clearance Insert SetupMiter Slot Alignment Tilt Stop AdjustmentDrive Belt Precision Miter GaugeLateral alignment Riving Knife AdjustmentArbor and Arbor Bearing Removal Insert AdjustmentOperating Controls Safety KeyStart/Stop Overview OperationsKickback Rip Sawing Crosscutting Do not use the standard table insert for dadoing operations Bevel and Miter OperationsFiller Piece Safety DevicesFeather Board and Push Blocks Push StickLubrication MaintenanceMiscellaneous Trouble TroubleshootingOrdering Replacement Parts Optional AccessoriesTable & Cabinet Assembly Model 2000 Table Saw Parts ListTable & Cabinet Parts Assembly PM2000-MFC Trunnion & Motor Assembly Parts ListPM2000-SCCA PM2000-288 Trunnion & Motor Assembly PM2000-AKPA Blade Guard & Miter Gauge Assembly Parts ListBlade Guard & Miter Gauge Assembly Side Cover Assembly 3HP, 230V, 1Phase Wiring Diagrams5HP, 230V, 1Phase Magnetic Switch Electrical BoardMagnetic Switch 5HP, 460V, 3Phase Page Page WMH Tool Group