Powermatic 2000 operating instructions Shipping Contents

Page 7

Shipping Contents

Unpacking

Remove box and wood crating completely from around saw. Check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Table Saw is assembled and running properly.

Compare the contents of your container with the parts lists in the next two pages to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

1.Unbolt the saw from the skid.

2.Carefully slide the saw from the pallet onto the floor.

Make sure that the castors do not get damaged when removing from the skid.

The Table Saw should be placed in an area with a sturdy level floor, good ventilation and sufficient lighting. Leave enough space around the machine for mounting extension wings and rail assemblies, and loading and off-loading stock and general maintenance work.

Cleaning

Exposed metal surfaces, such as the table top and extension wings, have been given a protective coating at the factory. This should be removed with a soft cloth moistened with kerosene. Do not use acetone, gasoline, or lacquer thinner for this purpose. Do not use solvents on plastic parts, and do not use an abrasive pad because it may scratch the surfaces.

7

Image 7
Contents Inch Cabinet Saw Warranty and Service Table of Contents Page Page Introduction Specifications Shipping Contents Contents of the Shipping Container Extension Tables Mounting Extension Wings AssemblyDust Chute Lock Knobs and Swivel HandlesMotor Cover Blade Installation/ReplacementDescription Riving Knife and Guard InstallationExtension Cords AdjustmentsHandwheel Adjustments Grounding InstructionsCastor system adjustment Zero-Clearance Insert SetupMiter Slot Alignment Tilt Stop AdjustmentDrive Belt Precision Miter GaugeLateral alignment Riving Knife AdjustmentArbor and Arbor Bearing Removal Insert AdjustmentOperating Controls Safety KeyStart/Stop Overview OperationsKickback Rip Sawing Crosscutting Do not use the standard table insert for dadoing operations Bevel and Miter OperationsFiller Piece Safety DevicesFeather Board and Push Blocks Push StickLubrication MaintenanceMiscellaneous Trouble TroubleshootingOrdering Replacement Parts Optional AccessoriesTable & Cabinet Assembly Model 2000 Table Saw Parts ListTable & Cabinet Parts Assembly PM2000-MFC Trunnion & Motor Assembly Parts ListPM2000-SCCA PM2000-288 Trunnion & Motor Assembly PM2000-AKPA Blade Guard & Miter Gauge Assembly Parts ListBlade Guard & Miter Gauge Assembly Side Cover Assembly 3HP, 230V, 1Phase Wiring Diagrams5HP, 230V, 1Phase Magnetic Switch Electrical BoardMagnetic Switch 5HP, 460V, 3Phase Page Page WMH Tool Group